The Avolites DMX splitter is now available in two versions
- Rack or Truss mounting
Avolites DMX splitters will buffer, multiply, isolate and protect
console DMX outputs.
The device operates from any AC mains voltage ( 85 to 265v )
with a robust 2 amp internal power supply. Standard units have
DMX in, DMX loop out, Terminate On switch and LED, plus additional
Power and Data LED's.
The Rack splitter provides four pairs of outputs and the Truss
splitter three pairs. These are optically isolated from each other
and can be standard 5 pin or 3 pin or 3 pin reverse. Internally,
the circuit board carries spare IC's enabling you to get up-and-running
again very fast in the case of an emergency.
The reliable and resilient principals of Tube Technology are
utilised by Avolites in the Truss Mounting DMX splitter. Cased
in a thick-wall, rigid plastic tube, the splitter is designed
to attach to anything. The use of two heavy duty velcro straps
means the Truss Mounting splitter needs no special clamps or other
fixings. In addition to the velcro, there is a safety wire and
clip.
|
| |
"DMX in" and "DMX loop out" |
| |
High brightness power and data LED's |
| |
Standard XLR5 ( optional XLR3 or XLR3 reverse polarity )
|
| |
Internal circuit board carries spare IC's |
| |
Operates from any AC mains voltage from 85-265 volts |
| |
"DMX in" and "DMX loop out" |
| |
High brightness power and data LED's |
| |
Standard XLR5 ( optional XLR3 or XLR3 reverse polarity )
|
| |
Internal circuit board carries spare IC's |
| |
Operates from any AC mains voltage from 85-265 volts |
| |
|
| |
|
| |
|
| |
|
| |
|
| |
|
| |
|
| |
|
